Clear WIXFBR-131

Please follow these instructions to configure your Clear WIXFBR-131 router to work with PhonePower. These instructions are only if you are connecting your phone adapter to your router.

---

• You will need the current IP address of your phone adapter.
  
• If you have a Grandstream phone adapter please refer to How to receive the current WAN IP Address on a Grandstream.
  
• If you have an Innomedia phone adapter please refer to How to receive the current WAN IP Address on an Innomedia.
  
• If you have an Obihai phone adapter please refer to How to receive the current WAN IP Address on an Obihai.
  
• Please write this IP Address down as you will need it in later steps

---

Click to enlarge

Open a web browser Enter http://192.168.15.1 into the address bar and press enter Log into the router. You will be prompted for a username and password. The default username is (blank) The default password is admin

---

• If the default password doesnt work, please contact Clear Wireless for the admin password for your device

---

Click to enlarge

• Select Advanced Settings from the menu on the left

---

Click to enlarge

• Select Router from the sub-menu
• Select Port Forwarding from the menu

---

Click to enlarge

• Click Add • Set Protocol to UDP • Set Begin to 5000 • Set End to 5080 • Set LAN IP to the IP address of your phone adapter • Ensure the Enabled box is checked

---

Click to enlarge

• Click Add • Set Protocol to UDP • Set Begin to 10000 • Set End to 11000 • Set LAN IP to the IP address of your phone adapter • Ensure the Enabled box is checked

---

Click to enlarge

• Click Add • Set Protocol to UDP • Set Begin to 12060 • Set End to 12080 • Set LAN IP to the IP address of your phone adapter • Ensure the Enabled box is checked

---

Click to enlarge

• Click Add • Set Protocol to UDP • Set Begin to 16384 • Set End to 16472 • Set LAN IP to the IP address of your phone adapter • Ensure the Enabled box is checked

---

Click to enlarge

• Click Add • Set Protocol to TCP • Set Begin to 4200 • Set End to 4200 • Set LAN IP to the IP address of your phone adapter • Ensure the Enabled box is checked

---

• Click Apply

---

• If your Clear device recommends that it be rebooted, please reboot the Clear device.

---

Note: If you are unable to place a call after 15 minutes, or any other irregularities appear, please contact our support department for additional assistance.