Comcast Netgear CG3000DCR

Please follow these instructions to configure your Comcast Netgear CG3000DCR router to work with PhonePower. These instructions are only if you are connecting your phone adapter to your router.

---

• You will need the current IP address of your phone adapter.
  
• If you have a Grandstream phone adapter please refer to How to receive the current WAN IP Address on a Grandstream.
  
• If you have an Innomedia phone adapter please refer to How to receive the current WAN IP Address on an Innomedia.
  
• If you have an Obihai phone adapter please refer to How to receive the current WAN IP Address on an Obihai.
  
• Please write this IP Address down as you will need it in later steps

---

Open a web browser Enter http://10.1.10.1 into the address bar and press enter Log into the router. You will be prompted for a username and password. The default username is cusadmin The default password is highspeed

---

---

Click to enlarge

• Go to Firewall on the left side of the page.

---

Click to enlarge

• Then, Click on DMZ.
• Enable DMZ Host and Enter in the IP address of the phone adapter.

• Then select Apply.

---

Note: If you are unable to place a call after 15 minutes, or any other irregularities appear, please contact our support department for additional assistance.