D-Link 4300

Please follow these instructions to configure your D-Link 4300 router to work with PhonePower. These instructions are only if you are connecting your phone adapter to your router.

---

• You will need the current IP address of your phone adapter.
  
• If you have a Grandstream phone adapter please refer to How to receive the current WAN IP Address on a Grandstream.
  
• If you have an Innomedia phone adapter please refer to How to receive the current WAN IP Address on an Innomedia.
  
• If you have an Obihai phone adapter please refer to How to receive the current WAN IP Address on an Obihai.
  
• Please write this IP Address down as you will need it in later steps

---

Open a web browser Enter http://192.168.0.1 into the address bar and press enter Log into the router. You will be prompted for a username and password. The default username is (blank) The default password is (blank)

---

Click to enlarge

• Once logged into the router, you will be on the device info page
• Click ADVANCED at the top.

---

Click to enlarge

• Click on FIREWALL.
• This will display the Firewall Settings page. Scroll down to application level gateway (ALG) configuration:
• Un-check the SIP option.
• Scroll up and click the Save Settings button.

---

Click to enlarge

• After you click save settings, you will be redirected to the following page:

• Click Reboot The Device.

---

Note: If you are unable to place a call after 15 minutes, or any other irregularities appear, please contact our support department for additional assistance.