D-Link DLG-4100

Please follow these instructions to configure your D-Link DLG-4100 router to work with PhonePower. These instructions are only if you are connecting your phone adapter to your router.

---

• You will need the current IP address of your phone adapter.
  
• If you have a Grandstream phone adapter please refer to How to receive the current WAN IP Address on a Grandstream.
  
• If you have an Innomedia phone adapter please refer to How to receive the current WAN IP Address on an Innomedia.
  
• If you have an Obihai phone adapter please refer to How to receive the current WAN IP Address on an Obihai.
  
• Please write this IP Address down as you will need it in later steps

---

Open a web browser Enter http://192.168.0.1 into the address bar and press enter Log into the router. You will be prompted for a username and password. The default username is Admin The default password is (blank)

---

After accessing the router administration, you'll be on the status tab.

• Click on the Advanced tab.
• Add the following virtual servers:

• Save the settings.

On the left of the Advanced tab:

• Click Firewall.
• Un-check SIP and then save the settings.

---

Note: If you are unable to place a call after 15 minutes, or any other irregularities appear, please contact our support department for additional assistance.