Initial-Sync-Instructions-for-the-PAP2TNA
Firmware: pap2t-5-1-3-LS
To configure your PAP2T-NA to work with Phone Power's service, you must know the admin credentials. If you do not, you should reset the device to the default factory configuration which does not have an admin password.
• To reset the device to the default factory configuration, dial **** and at the prompt dial 73738# and then press 1 to confirm. You will then need to log into the web interface on the device.
• If you don't know the device's IP, you can pickup the handset, dial **** and then 110# to receive the IP Address.
• After you have the device's IP address, enter the following URL:
http://<<InsertDeviceIpHere>>/admin/resync?https://provision.phonepower.com/linksys/ProvisionXml.php?sn=$SN&mac=$MA
- NOTE: Enter the entire link as it is displayed exactly. The link might look like it is 2 seperate links. The only change that must be made to the link is to replace the '<<InsertDeviceIpHere>>' with the IP address that you received in the first steps.
After your device reboots, please wait for the Phone 1 light to light up.
When the device is ready, you should be able to make an receive calls.
If you are unable to place a call after 15 minutes, please contact our support department for additional assistance.
