Initial-Sync-Instructions-for-the-WRTGP2-NA

To configure the WRT54GP2-NA to work with Phone Power's service, you must know the admin credentials for the device. If you do not, you should reset the device to factory defaults.

• To reset the device to the factory default configuration, press and hold the reset button located on the back of the device for 30 seconds.

• You will then need to log into the web interface on the device and have a computer connected to the Ethernet port on the device.
  You will need the device's IP address to do this. If you reset the device to factory defaults, this will be 192.168.15.1.
• After you have the device's IP address, enter the following URL into your web browser:
  

http://<<InsertDeviceIpHere>>/admin/resync?https://provision.phonepower.com:4443/linksys/ProvisionXml.php?sn=$SN&mac=$MA

Attention
	Enter the entire link as it is displayed exactly. The link might look like it is 2 separate links, it is indeed a single long link. The only change that must be made to the link is to replace the '<<InsertDeviceIpHere>>' with the IP address that you received in the first steps.

It will ask you for your username and password at this point; if you reset your device to factory defaults.

• User name – admin
• Password – admin

After your device reboots, the Phone 1 light will light up when the device is ready to make and receive calls. At this time you are ready to use your Phone Power service.