Initial Sync Instructions for the SPA 1001
From PhonePower Knowledge Base
To configure your SPA1001 to work with Phone Power's service, you must know the admin credentials. If you do not, you should reset the device to the default factory configuration which does not have an admin password. To reset the device to the default factory configuration, dial **** and at the prompt dial 73738# and then press 1 to confirm. You will then need to log into the web interface on the device. If you don't know the device's IP, you can pickup the handset, dial **** and then 110# to get it.
After you have the device's IP address, enter the following URL:
http://<<InsertDeviceIpHere>>/admin/resync?https://provision.phonepower.com/linksys/ProvisionXml.php?sn=$SN&mac=$MA
After your device reboots, the Phone 1 light will light up when the device is ready to make and receive calls. At this time you are be ready to use your Phone Power service.
After you have the device's IP address, enter the following URL:
http://<<InsertDeviceIpHere>>/admin/resync?https://provision.phonepower.com/linksys/ProvisionXml.php?sn=$SN&mac=$MA
After your device reboots, the Phone 1 light will light up when the device is ready to make and receive calls. At this time you are be ready to use your Phone Power service.
