Initial Sync Instructions for the SPA 2000
From PhonePower Knowledge Base
To configure your SPA2000 to work with Phone Power's service, you must know the admin credentials. If you do not, you should reset the device to the default factory configuration which does not have an admin password. To reset the device to the default factory configuration, dial **** and at the prompt dial 73738# and then press 1 to confirm. You will then need to log into the web interface on the device and have a computer connected to the Ethernet port on the device. If you have changed the IP of the SPA2000, use that IP in place of the one below.
Enter the following URL:
http://192.168.0.1/admin/resync?https://provision.phonepower.com/linksys/ProvisionXml.php?sn=$SN&mac=$MA
After your device reboots, the Phone 1 light will light up when the device is ready to make and receive calls. At this time you are be ready to use your Phone Power service.
Enter the following URL:
http://192.168.0.1/admin/resync?https://provision.phonepower.com/linksys/ProvisionXml.php?sn=$SN&mac=$MA
After your device reboots, the Phone 1 light will light up when the device is ready to make and receive calls. At this time you are be ready to use your Phone Power service.
