Initial Sync Instructions for the SPA 525G
From PhonePower Knowledge Base
To configure your SPA525G to work with Phone Power's service, you must know the admin credentials. If you do not, you should reset the device to the default factory configuration which does not have an admin password. To reset the device to the default factory configuration, press the option key and select option 9, then option 5, then press OK. You will then need to log into the web interface on the device.
To determine the IP address of the device, press the option key and select option 10, then option 2. After you have the device's IP address, enter the following URL:
http://<<InsertDeviceIpHere>>/admin/resync?https://provision.phonepower.com/linksys/ProvisionPhoneXml.php?sn=$SN&mac=$MA
After your device reboots, the phone will display your phone number next to the softkeys when the device is ready to make and receive calls. At this time you are be ready to use your Phone Power service.
To determine the IP address of the device, press the option key and select option 10, then option 2. After you have the device's IP address, enter the following URL:
http://<<InsertDeviceIpHere>>/admin/resync?https://provision.phonepower.com/linksys/ProvisionPhoneXml.php?sn=$SN&mac=$MA
After your device reboots, the phone will display your phone number next to the softkeys when the device is ready to make and receive calls. At this time you are be ready to use your Phone Power service.
