Linksys WRT1900AC
Please follow these instructions to configure your Linksys WRT1900AC router to work with PhonePower. These instructions are only if you are connecting your phone adapter to your router.
- You will need the current IP address of your phone adapter.
- If you have a Grandstream phone adapter please refer to How to receive the current WAN IP Address on a Grandstream.
- If you have an Innomedia phone adapter please refer to How to receive the current WAN IP Address on an Innomedia.
- If you have an Obihai phone adapter please refer to How to receive the current WAN IP Address on an Obihai.
- Please write this IP Address down as you will need it in later steps
|
Once logged in, click on Security.
Uncheck SPI firewall protection for both Ipv4 and IPv6
Still under the security window
Click on Apps and Gaming
Under this select Port Range Forwarding
Click on Add a new Port Range Forwarding
• Assign the ports to the IP address as shown below.
• Port ranges to forward are:
• PhonePower1 5004-5012 Protocol: UDP
• PhonePower2 5060-5061 Protocol: UDP
• PhonePower3 10000-10000 Protocol: UDP
• PhonePower4 12060-12061 Protocol: UDP
• PhonePower5 16600-16798 Protocol: UDP
Click Apply when done
Still under Apps and Gaming
Click on Single Port Forwarding
Click on Add a new Single Port Forwarding
• Assign the ports to the IP address as shown below.
• Port ranges to forward are:
• PhonePower6 4200-4200 Protocol: TCP
Click on Connectivity
Under connectivity
Click the Administration tab
Uncheck SIP ALG
Click Apply to save setting
Note: If you are unable to place a call after 15 minutes, or any other irregularities appear, please contact our support department for additional assistance.
