NetGear R6250

Please follow these instructions to configure your NetGear R6250 router to work with PhonePower. These instructions are only if you are connecting your phone adapter to your router.

---

• You will need the current IP address of your phone adapter.
  
• If you have a Grandstream phone adapter please refer to How to receive the current WAN IP Address on a Grandstream.
  
• If you have an Innomedia phone adapter please refer to How to receive the current WAN IP Address on an Innomedia.
  
• If you have an Obihai phone adapter please refer to How to receive the current WAN IP Address on an Obihai.
  
• Please write this IP Address down as you will need it in later steps

---

Open a web browser Enter http://192.168.0.1 into the address bar and press enter Log into the router. You will be prompted for a username and password. The default username is admin The default password is password

---

Click to enlarge

• Click the Advanced Tab towards the top of the screen

---

Click to enlarge

• Click Advanced Setup in the menu on the left • Click Port Forwarding/Port Triggering

---

Click to enlarge

• Click + Add Custom Service

---

Click to enlarge

• Enter PhonePower1 for the Service Name • Select UDP for Service Type • Enter 5004 for the External Starting Port • Enter 5012 for the External Ending Port • Make sure Use the same port range for internal port is checked • Enter the IP address of your phone adapter for Internal IP Address • Click Apply

---

Click to enlarge

• Add another custom service • Enter PhonePower2 for the Service Name • Select UDP for Service Type • Enter 5060 for the External Starting Port • Enter 5061 for the External Ending Port • Make sure Use the same port range for internal port is checked • Enter the IP address of your phone adapter for Internal IP Address • Click Apply

---

Click to enlarge

• Add another custom service • Enter PhonePower3 for the Service Name • Select UDP for Service Type • Enter 10000 for the External Starting Port • Enter 10000 for the External Ending Port • Make sure Use the same port range for internal port is checked • Enter the IP address of your phone adapter for Internal IP Address • Click Apply

---

Click to enlarge

• Add another custom service • Enter PhonePower4 for the Service Name • Select UDP for Service Type • Enter 12060 for the External Starting Port • Enter 12061 for the External Ending Port • Make sure Use the same port range for internal port is checked • Enter the IP address of your phone adapter for Internal IP Address • Click Apply

---

Click to enlarge

• Add another custom service • Enter PhonePower5 for the Service Name • Select TCP/UDP for Service Type • Enter 4200 for the External Starting Port • Enter 4200 for the External Ending Port • Make sure Use the same port range for internal port is checked • Enter the IP address of your phone adapter for Internal IP Address • Click Apply

---

Note: If you are unable to place a call after 15 minutes, or any other irregularities appear, please contact our support department for additional assistance.