Xfinity
Please follow these instructions to configure your Xfinity router to work with PhonePower. These instructions are only if you are connecting your phone adapter to your router.
- You will need the current IP address of your phone adapter.
- If you have a Grandstream phone adapter please refer to How to receive the current WAN IP Address on a Grandstream.
- If you have an Innomedia phone adapter please refer to How to receive the current WAN IP Address on an Innomedia.
- If you have an Obihai phone adapter please refer to How to receive the current WAN IP Address on an Obihai.
- Please write this IP Address down as you will need it in later steps
|
• If the default username and password do not work please contact your ISP and request the administrator log in credentials for your modem/router
• Please Navigate under where it says: Connected Devices > Computers
• Then, click Edit to modify the connection setting for the selected device.
• Change the configuration to Reserved IP
• This will now give you an Input Box to enter the IP number needed to be reserved.
• Then, navigate to the menu on the left: Advanced > Port Forwarding
• Please select Enable > Port Forwarding
|
Example: • Add Port Forwarding • Then, Click Save |
• You will need to create a Port Forwarding rule for each of the below.
| Protocol Ports Both 4200 |
Note: If you are unable to place a call after 15 minutes, or any other irregularities appear, please contact our support department for additional assistance.
